Topic's about PicEngrave Pro 5 or 6
Forum rules
Be Kind to other's.
No Cussing or Swearing.
Don't post anything Illegal or Obscene.
Image attachment size limit is 500 Kib.
Dominic Galligan
Posts: 9
Joined: Wed Jun 21, 2017 3:53 am


Postby Dominic Galligan » Sat Feb 10, 2018 5:37 am

Hi all. Is there a way to know what settings to use with different photos? I got the software to be able to engrave photos with emblaser but have found it very hard to workout the right settings to use. The only way I could do it is to print out the photo then work out from that what needs to be changed. Which is a waste of material and time.

User avatar
Full Access Moderator
Posts: 1092
Joined: Thu Dec 18, 2014 4:02 pm

Re: photos

Postby Picengravertoo » Sat Feb 10, 2018 9:41 am

Hi Dominic,

You need photos with a contrast of colors or shades, so that will be reflected on your laser engraving. Are you using the PicLaser image editor? If so, the Preview Gray Scale selection will give you a general idea how it will laser engrave with your EmBlaser.

However, the overall darkness/lightness will be determined by the feedrate setting and it needs to be set based on each type of material your engraving on. I always sand across the grains of wood with fine sandpaper first. Not all types of wood burns even close to linear either. I have the best results with minimal grain woods like Birch Ply, Poplar (without any green coloring) or Basswood.

I always use a 255 (full power) for the Max Laser Value and adjust the feedrate until the darkest shades engrave to my liking, then adjust the Min Laser Value to where the lightest shades just start to lightly burn.

Here is some instructions I did for our PicLaser Lite that was included in the LazerBlade (EmBlaser) KickStarter Campaign. ... test-image

PicLaser is generally the same program with the Image editor that we added later. There is an image example to test with there. The original and after editing. Depending on your EmBlaser's Laser wattage and the material your engraving on, you will have to adjust the Pixel Resolution (burn line step over), feedrate and the Min Laser Value.


Dominic Galligan
Posts: 9
Joined: Wed Jun 21, 2017 3:53 am

Re: photos

Postby Dominic Galligan » Sat Feb 10, 2018 6:47 pm

Thanks Jeff

Return to “PicEngrave Pro 5 or 6”

Who is online

Users browsing this forum: No registered users and 2 guests