I'm not sure this is where to ask my questions about my new laser build but correct me if I am in the wrong spot.
I did see the Shapeoko Calculator but I am at a loss as to what to put in the little boxes. To start with this is a picture of the stepper driver setup for the Dip Switches. How do I know where to start? You know I really think I am getting to old for this.
I have this set at 3200 on the Mach 3 machine but that is only a guess and it worked but there are a lot of options?????
Also keep in mind I don't know how or what I am doing.
Thanks again Jerry