Page 2 of 2

Re: import g code from easel

Posted: Sat Dec 05, 2020 4:01 pm
by Chic Dortmund
Trying to open picsender on my ofice PC but asks for my registration code....didn't write it down...
I apparently have to load the file and edit out the m7...?
Only is a problem exporting from Easel on lap top

Re: import g code from easel

Posted: Sat Dec 05, 2020 6:53 pm
by Picengraver
We will resend your registration email shortly.

Maybe there is a setting is Easel to stop adding M7???

EDIT: Email sent

Re: import g code from easel

Posted: Sat Dec 05, 2020 10:17 pm
by Chic Dortmund
FYI...Easel under machine/advanced has a checkbox to allow the addition of M7, M8, M9 to generated files. Must have that option checked on my lap top. Was a newer addition under the beta version of the software.....wasnt aware...

Thanks for all your help and support. Maybe this will help someone else if the problem crosses your desk again.
Great program....just finr tuning the learning curve.

Chic Dortmund

Re: import g code from easel

Posted: Sat Dec 05, 2020 10:18 pm
by Picengraver
Thank you for the feedback.
All the best,
John