It can be seen here:
http://www.instructables.com/id/CNC-Spi ... nhancemen/
This engraving was done on Poplar with our EmBlaser using the Feed Rate Change added to PicLaser Lite gcode.
- Roy2.jpg (425.82 KiB) Viewed 10333 times
PicFRC instructables
Forum rules
Be Kind to other's.
No Cussing or Swearing.
Don't post anything Illegal or Obscene.
Image attachment size limit is 500 KiB.
Be Kind to other's.
No Cussing or Swearing.
Don't post anything Illegal or Obscene.
Image attachment size limit is 500 KiB.
-
Picengravertoo
- Full Access Moderator
- Posts: 1092
- Joined: Thu Dec 18, 2014 4:02 pm
- Contact:
PicFRC instructables
We wrote an instructables explaining how to use PicFRC with PicLaser Lite generated Gcode.
It can be seen here:
http://www.instructables.com/id/CNC-Spi ... nhancemen/
This engraving was done on Poplar with our EmBlaser using the Feed Rate Change added to PicLaser Lite gcode.
It can be seen here:
http://www.instructables.com/id/CNC-Spi ... nhancemen/
This engraving was done on Poplar with our EmBlaser using the Feed Rate Change added to PicLaser Lite gcode.
Re: PicFRC instructables
Hi Jeff,
FRC is like VFR in Pic5?
Really cool job, very nice.
Saludos,
Jose
FRC is like VFR in Pic5?
Really cool job, very nice.
Saludos,
Jose
-
Picengravertoo
- Full Access Moderator
- Posts: 1092
- Joined: Thu Dec 18, 2014 4:02 pm
- Contact:
Re: PicFRC instructables
Thanks Jose,
PicFRC is like the "Feed Rate Change" in PEP5, but it adds it to the file after generating the gcode in PicLaser Lite. VFR, does not have power commands or axis depths on each line, but FRC does.
Jeff
PicFRC is like the "Feed Rate Change" in PEP5, but it adds it to the file after generating the gcode in PicLaser Lite. VFR, does not have power commands or axis depths on each line, but FRC does.
Jeff
Who is online
Users browsing this forum: No registered users and 3 guests