Communication error with GRBL

Topic's about PicSender
Forum rules
Be Kind to other's.
No Cussing or Swearing.
Don't post anything Illegal or Obscene.
Image attachment size limit is 500 KiB.
Posts: 14
Joined: Thu Aug 01, 2019 5:34 pm

Communication error with GRBL

Postby davet354tfd » Sat Jan 28, 2023 3:52 pm

Been running a carve today. V-Carve said it would take just under 2 hours. I have carved longer than this before.
But about 45 minutes into the carve I get a "Unknown problem has been detected Communicating with GRBL"
This happened 3 times today on the same carve.
I finally broke it up into 8 separate carves to get it done.

I finally turned off my wifi.

Computer is updated.

I have had this happen 1 or 2 times in 2 or 3 years.

I will check the cables.

But I have no other ideas on what to look at/for to eliminate this problem.



Return to “PicSender”

Who is online

Users browsing this forum: No registered users and 3 guests