Page 1 of 1

Triquetra

Posted: Wed Mar 03, 2021 4:23 pm
by davet354tfd
Thinking about geting a Triquetra.

So far i have not found anything on how it interfaces with picsender (if it can).

Any help or suggestions would be great.

Thanks

Bob

Re: Triquetra

Posted: Thu Mar 04, 2021 8:33 am
by Picengraver
Bob,
The Triquetra uses a standard gcode file to zero your bit to a work piece. There is no special "interface" required for using one with PicSender. I have used one since Charlie first started producing them. You can load the gcode file for your Triquetra into one of the QCodes positions (click the blue Quick Codes button) so it is easy to run whenever you need it. More info is in the PicSinder Tutorial (click the Help or Tutorial button at the bottom of the PicSender screen, then click the yellow Tutorial button on the popup window). Please let me know if you need more info.
John Champlain
QCode.jpg
QCode.jpg (83.81 KiB) Viewed 590 times

Tutorial.jpg
Tutorial.jpg (171.69 KiB) Viewed 590 times

Re: Triquetra

Posted: Thu Mar 04, 2021 10:53 am
by davet354tfd
John:

So what you are telling me, is that it works well with picsender and it makes zeroing easy.
Will look into the tutorial.

Thanks

Bob

Re: Triquetra

Posted: Thu Mar 04, 2021 2:28 pm
by Picengraver
Yes, it make zeroing your bit to your work piece much easier, and allows you to recover easier from some carving/machine mishaps.
You can also contact Charley Thomas directly for additional help:
https://triquetra-cnc.com/